19761

Rule Lowpro Automatic Pump

From
$59.99
Learn More
Check Store Availability

We don't have enough stock on hand.

Adding to cart… The item has been added
Added to Cart

The automatic LoPro includes all features as detailed further above with the additional benefit of automatic operation in multiple modes- NO float switch is required.

  • High or low water sensing mode - the pump can be set to start operation at either 33mm or 50mm bilge water height
  • Electronic automatic timer mode - The pump can be set to automatically check for water every 2 1/2 minutes - if water is present it will continue to run and pump bilge water. This feature is very handy - however if you leave the boat unattended on a mooring it may run down the battery over time, if you don’t have solar panels or a wind generator Etc to constantly charge the battery - in this case set the pump only to high or low mode
  • Includes pump test mode
  • Includes manual over-ride 3rd wire - requires a Rule 3 way panel switch RWB23 or 107 to operate this feature - see next page

12 volt 4 amp use a 7.5 amp fuse
12 volt DC only - DO NOT run direct off a 240v-12v transformer

WASHING INSTRUCTIONS:

Machine wash separately in cold water on a gentle cycle. Tumble dry separately on low heat. Add QE Home Wool Dryer Balls to reduce wrinkles and increases drying efficiency. Touch up with a low heat iron as needed. Do not bleach or dry clean.

Reviews